Stainless Steel Surfaces - GE JKP15 Owner's Manual

Socket
3 1 ⁄ "
2
Maximum
length
Bulb
Tab
Glass cover
Wire cover holder

Stainless Steel Surfaces

Do not use a steel-wool pad; it will scratch
the surface.
To clean the stainless-steel surface, use a
hot, damp cloth with a mild detergent
suitable for stainless-steel surfaces. Use a
clean, hot, damp cloth to remove soap.
Dry with a dry, clean cloth.
If food soil remains, try a general
kitchen cleaner, such as Fantastik®,
Simple Green®, or Formula 409®.
For hard-to-clean soil, use a standard
stainless-steel cleaner, such as Bon-Ami®
or Cameo®.
Oven Light Bulb
(on some models)
NOTE: The glass cover (on some models) should
be removed only when cold. Wearing latex gloves
may offer a better grip.
Before replacing the bulb, disconnect
electrical power to the oven at the main
fuse or circuit breaker panel. Let the bulb
cool completely before removing it. For
your safety, do not touch a hot bulb with a
damp cloth. If you do, the bulb will break.
To remove:
Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass cover
clear the grooves of the socket. Remove
the bulb.
Oven Light Bulb
(on some models)
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the oven at the
main fuse or circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn't fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt
appliance bulb.
(on some models)
Apply cleaner with a damp sponge.
Use a clean, hot, damp cloth to remove
cleaner. Dry with a dry, clean cloth.
Always scrub lightly in the direction of
the grain.
After cleaning, use a stainless-steel
polish, such as Stainless Steel Magic®,
Revere Copper and Stainless Steel
Cleaner®, or Wenol All Purpose Metal
Polish®. Follow the product instructions
for cleaning the stainless-steel surface.
To replace:
Put in a new 40-watt appliance bulb. Place
the tabs of the glass cover into the grooves
of the socket. Turn the glass cover
clockwise 1/4 turn.
NOTE:
A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
Install and tighten the cover clockwise.
Reconnect electrical power to the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is
completely cool.
To replace the cover:
Place it into grooves of the light
receptacle. Pull wire forward to
the center of the cover until it
snaps into place.
Connect electrical power to
the oven.
21