Table of Contents
Advertisement
46
8.
Verify that the antenna cable is routed in the shortest way to minimize power loss over the
cable.
9.
Check that the mounting surfaces are able to support the weight of the units.
MOTOCYCLE MOUNT ENHANCED CONTROL HEAD
Installing the Motorcycle Mount Enhanced Control Head
1.
Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps
into place.
2.
Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount
Enhanced Control Head for an optimum view of the display. Then, complete the tightening of
the screws.
3.
There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of
allowable movement, as shown in Figure 17 and Figure 18:
MTM5400 Mobile Terminal Installation Manual
If an additional GPS antenna or a combined TETRA/GPS
antenna is used, the antenna housing carries the GPS
receiver. Take care not to cover the antenna housing with
metal or other radio wave absorbing material.
TRANSCEIVER-TO-CONTROL HEAD CABLE
P/N: PMKN4030
FUSE
BLOCK
CHASSIS GROUND
P/N: GKN6270 (3m, FUSE 10A)
Figure 16 Motorcycle Installation
TRANSCEIVER
LOUDSPEAKER
BATTERY
FUSED POWER CABLE
INSTALLATION
FIST MICROPHONE CABLE
P/N: PMKN4029
use with the Mic or Handset
FIST MICROPHONE
MOTORCYCLE BOX
ANTENNA
Advertisement
Table of Contents
