Mitsubishi Electric UD8400U Manual page 4

• The projector may not receive a command when the splash screen is being displayed immediately after
turning on the power. Use command "00r10" to cancel the splash screen.
• While using the LAN terminals, the LAN functions take precedence.
• For the LAN terminals, the same commands as those for connecting with the TCP/IP (port number 63007) are
available. Note, however, that the response becomes slightly slower than when using the RS-232C terminals.
For the use of LAN terminals, see page 17.
[Example 1] Turning ON the power. (Values enclosed in quotation marks are ASCII codes.):
• When ID is not specified:
Command sent from the PC
'30' '30' '21' '0D'
00!
• When ID is specified (when the command is sent to the projector with the ID of "01" or "ALL"):
Command sent from the PC
'30' '30' '3B' '30' '31' '3B' '21' '0D'
00;01;!
[Example 2] Selecting VIDEO as the input signal during auto positioning (Values enclosed in quotation marks are
ASCII codes.):
• When ID is not specified:
Command sent from the PC
30' '30' '5F' '76' '31' '0D'
00_v1
• When ID is specified (when the command is sent to the projector with the ID of "01" or "ALL"):
Command sent from the PC
'30' '30' '3B' '30' '31' '3B' '5F' '76' '31'
'0D'
00;01;_v1
• The flowchart on the next page shows the recommended operating sequence for your reference to create a
program.
Status code returned
from the projector
'30' '30' '21' '0D'
00!
Status code returned
from the projector
'30' ' 30' '3B' '30' '31' '3B' '21' '0D'
00;01;!
Status code returned
from the projector
'30' '30' '5F' '76' '31' '3A ''4E' '0D'
00_v1:N
Status code returned
from the projector
'30' '30' '3B' '30' '31' '3B' '5F' '76' '31'
'3A' '4E' '0D'
00;01;_v1:N
4
Description
Command for POWER ON
(ID command is omitted.)
Command receipt confirmation
(The statuses are echoed back as
many as the number of the connected
projectors.)
Description
Command for POWER ON is sent to
the projector with the ID of "01" or
"ALL."
The projector with the ID of "01"
or "ALL" receives the command.
(The status is echoed back from the
projector with the ID of "01" or "ALL.")
Description
(During auto positioning)
Command for selecting VIDEO as the
input signal is sent out.
The command is received by the
projector but cannot be executed.
(NAK return)
Description
(During auto positioning)
Command for selecting VIDEO as the
input signal is sent to the projector
with the ID of "01" or "ALL."
The projector with the ID of "01" or
"ALL" receives the command, but
cannot execute it.
(NAK return)