Cleaning and care
Triple filter system
The triple filter system in the base of the
wash cabinet retains coarse dirt from
the suds solution, preventing it from
reaching the circulation system and
re-entering the cabinet through the
The dishwasher must not be
used without all the filters in place.
Collection of coarse dirt may cause the
filters to clog. The level of soiling and
time it takes before the filters need
cleaning will vary depending on your
in the display after every 50 program
cycles (factory default setting).
The filter check frequency can be set
from 30 and 60 program cycles (see
"Settings, filter check").
^ Check the triple filter system.
^ Clean the triple filter, if necessary.
^ Confirm the message with the center
The last selected program is displayed
briefly and the respective indicator light
After a short while, the estimated
program time is displayed.
Cleaning the filters
^ Turn the dishwasher off.
^ Turn the handle counter-clockwise to
release the triple filter system
^ Take the filter combination out
remove any coarse particles and
rinse the filter well under running
water. Use a brush if necessary.
the filters, no coarse dirt falls into the
circulation system, causing a
Make sure that when cleaning