Checking The Neutral Switch; Checking The Cdi Unit; Starting Circuit Cut-Off System Operation; Electric Starting System - Yamaha WR250F(D) Owner's Service Manual

Wr series
Table of Contents

Advertisement

3. Inspect:
• Secondary coil resistance
Out of specification → Replace.
Tester (+) lead → Orange lead "1"
Tester (-) lead → Spark plug termi-
nal "2"
Secondary
Tester se-
coil resis-
lector posi-
tance
4.6–6.8
kΩat 20 °C
(68 °F)
4. Inspect:
• Sealed portion of ignition coil "a"
• Spark plug terminal pin "b"
• Threaded portion of spark plug "c"
Wear → Replace.
CHECKING THE AC MAGNETO
1. Inspect:
• Pickup coil resistance
Out of specification → Replace.
Tester (+) lead → Red lead "1"
Tester (-) lead → White lead "2"
Tester se-
Pickup coil
lector posi-
resistance
248–372 Ω
at 20 °C (68
°F)
CHECKING THE NEUTRAL
SWITCH
1. Inspect:
• Neutral switch conduction
Tester (+) lead→Sky blue lead "1"
Tester (-) lead → Ground "2"
tion
Not conductive while it is in neutral →
kΩ × 1
Replace.
Conductive while it is engaged → Re-
place.
Set the tester selection position to "Ω
× 1".

CHECKING THE CDI UNIT

Check all electrical components. If no
fault is found, replace the CDI unit.
Then check the electrical compo-
nents again.
ELECTRIC STARTING
SYSTEM
STARTING CIRCUIT CUT-OFF
SYSTEM OPERATION
If the main switch is set to "ON", the
starter motor can only operate if at
least one of the following conditions is
met:
• The transmission is in neutral (the
neutral switch is closed).
• The clutch lever is pulled to the han-
dlebar (the clutch switch is closed).
tion
The starting circuit cut-off relay pre-
vents the starter motor from operating
when neither of these conditions has
Ω × 100
been met. In this instance, the start-
ing circuit cut-off relay is open so cur-
rent cannot reach the starter motor.
When at least one of the above con-
ditions has been met the starting cir-
cuit cut-off relay is closed and the
engine can be started by pressing the
start switch.
WHEN THE TRANSMISSION IS IN
NEUTRAL
WHEN THE CLUTCH LEVER IS
PULLED TO THE HANDLEBAR

ELECTRIC STARTING SYSTEM

Result
Conductive (while gear
is in neutral)
7-5
1.
Battery
2.
Main fuse
3.
Main switch
4.
Starting circuit cut-off relay
5.
Start switch
6.
Diode
7.
Clutch switch
8.
Neutral switch
9.
Starter relay
10. Starter motor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wr205fWr205fr2013 wr205f2013 wr205fd

Table of Contents