Special Tools - Yamaha WR250F(R) Owner's Service Manual

SPECIAL TOOLS

The proper special tools are necessary for complete and accurate tune-up and assembly. Using the correct special tool
will help prevent damage caused by the use of improper tools or improvised techniques. The shape and part number used
for the special tool differ by country, so two types are provided. Refer to the list provided to avoid errors when placing an
order.
NOTE:
• For U.S.A. and Canada, use part number starting with "YM-", "YU-" or "ACC-".
• For others, use part number starting with "90890-".
Part number
YU-1135-A, 90890-01135
YU-3097, 90890-01252
YU-1256
YU-90050, 90890-01274
YU-90050, 90890-01275
YM-91044, 90890-04081
YU-90063, 90890-01278
YU-1304, 90890-01304
YU-24460-01, 90890-01325
YU-33984, 90890-01352
YU-33975, 90890-01403
YM-1423, 90890-01423
YM-01442, 90890-01442
Tool name/How to use
Crankcase separating tool
These tool is used to remove the crankshaft from
either case.
Dial gauge and stand
Stand
These tools are used to check each part for runout or
bent.
Crankshaft installing tool
Crankshaft installing pot
Crankshaft installing bolt
Spacer (crankshaft installer)
Adapter (M12)
These tools are used to install the crankshaft.
Piston pin puller set
This tool is used to remove the piston pin.
Radiator cap tester
Radiator cap tester adapter
These tools are used for checking the cooling
system.
Steering nut wrench
This tool is used when tighten the steering ring nut to
specification.
Damper rod holder
Use this tool to remove and install the damper rod.
Fork seal driver
This tool is used when install the fork oil seal.
SPECIAL TOOLS
1 - 11
GEN
INFO
Illustration