Yamaha WR250R Owner's Manual page 19

1 2
3
1. Stopwatch indicator " "
2. Tripmeter A indicator " "/Distance-com-
pensation tripmeter " "
3. Tripmeter B indicator " "
TIP
The multi-function display can be

set to the basic mode or the mea-
surement mode.
Tripmeter A will automatically re-

set to zero when changing from
the basic mode to the measure-
ment mode or vice versa.
Basic mode:
a speedometer

an odometer

two tripmeters (which show the

distance traveled since they were
INSTRUMENT AND CONTROL FUNCTIONS
last set to zero)
a fuel reserve tripmeter (which

shows the distance traveled since
the fuel level warning light came
on)
a clock

a self-diagnosis device

Measurement mode:
a speedometer

a distance-compensation tripme-

ter (which shows the accumulated
distance traveled since set to zero
and which can be calibrated to pro-
vide a more accurate tripmeter
reading)
a stopwatch (which shows the time

that has been accumulated since
the start of stopwatch measure-
ment)
a self-diagnosis device

TIP
Be sure to turn the key to "ON" be-

fore using the "SELECT 1", "SE-
LECT 2" and "RESET" buttons.
When the key is turned to "ON", all

of the display segments of the
multi-function display will appear
3-4
and then disappear, in order to test
the electrical circuit.
For the U.K. only: To switch the

speedometer and odometer/trip-
meter displays between kilometers
and miles, press the "SELECT 2"
button until the display changes af-
ter the key is turned to "ON".
Basic mode
Odometer and tripmeter modes
Push the "SELECT 2" button to switch
the display between the odometer
mode and the tripmeter modes A and B
in the following order:
odometer  tripmeter A  tripmeter B
 odometer
2
3
4
5
6
7
8
9