Yamaha WR450F(T) Owner's Service Manual page 598

1
2
3
5 - 44
HANDLEBAR
9. Install:
• "ENGINE STOP" button 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
4 Nm (0.4 m · kg, 2.9 ft · lb)
• Hot starter lever holder 4
• Bolt (hot starter lever holder) 5
4 Nm (0.4 m · kg, 2.9 ft · lb)
• Clamp 6
NOTE:
• The "ENGINE STOP" button, clutch lever
holder and clamp should be installed accord-
ing to the dimensions shown.
• Pass the "ENGINE STOP" button lead in the
middle of the clutch lever holder.
10. Install:
• Clutch cable 1
• Hot starter cable 2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
11. Adjust:
• Clutch lever free play
Refer to "CLUTCH ADJUSTMENT" sec-
tion in the CHAPTER 3.
• Hot starter lever free play
Refer to "HOT
ADJUSTMENT" section in the CHAPTER
3.
12. Fasten the hot starter cable 1 and clutch
cable 2 with a clamp 3.
CHAS
STARTER LEVER