Yamaha WR450F(S) Owner's Service Manual page 694

Wr series
Hide thumbs Also See for WR450F(S):
Table of Contents

Advertisement

TPS (THROTTLE POSITION SENSOR) SYSTEM
4. Adjust:
Idle speed
G
Refer to "IDLE SPEED ADJUST-
MENT" section in the CHAPTER 3.
5. Insert the thin electric conductors 2
(lead) into the TPS coupler 1, as shown,
and connect the tester to them.
Tester (+) lead → Yellow lead 3
Tester (–) lead → Black lead 4
CAUTION:
Do not insert the electric conductors
G
more than required because it may
reduce the waterproof function of the
coupler.
Make sure that a short-circuit does not
G
develop between the terminals because it
may cause damage to electrical compo-
nents.
6. Start the engine.
7. Adjust:
TPS output voltage
G
Adjustment steps:
Adjust the installation angle of the TPS 1
to obtain the specified output voltage.
NOTE:
Measure the output voltage accurately with a
digital electronic voltmeter that gives an easy
reading of a small voltage.
TPS output
voltage
0.58 ~ 0.78 V
6 - 22
+
ELEC
Tester selector
position
DCV

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wr450fWr450 fs 2004

Table of Contents