Yamaha YZ125(V) Owner's Service Manual page 438

FRONT FORK
27. Install:
9 Push rod 1
9 Copper washer 2
9 Adjuster 3
To damper assembly 4.
NOTE:
9While compressing the inner tube 5, set the
cap bolt ring wrench 7 between the inner tube
and locknut 6.
9Fully finger tighten the adjuster onto the
damper assembly.
Cap bolt ring wrench:
YM-01501/90890-01501
28. Inspect:
9 Gap a between adjuster 1 and locknut 2.
Out of specification¡ Retighten and read-
just the locknut.
Gap a a between adjuster and locknut :
0.5 ~1.0mm (0.02~0.04 in)
NOTE:
If the adjuster is installed out of specification,
proper damping force cannot be obtained.
29. Tighten:
9 Adjuster (locknut) 1
NOTE:
Hold the locknut 2 and tighten the adjuster with
specified torque.
30. Install:
9 Adjuster 1
To inner tube.
31. Fill:
9 Front fork oil 1
From outer tube top.
Recommended oil:
Suspension oil "S1"
Standard oil amount:
340 cm
*335 cm
Extent of adjustment:
300 ~380 cm
10.1~12.8 US oz)
*For EUROPE
5-39
CHAS
29 Nm (2.9 m•kg, 21 ft•lb)
55 Nm (5.5 m•kg, 40 ft•lb)
3 (12.0 Imp oz, 11.5 US oz)
3 (11.8 Imp oz, 11.3 US oz)
3 (10.6~13.4 Imp oz,