Adapter Plugs; Extension Cords; Grounding Instructions; Light Bulb Replacement - GE Spacemaker 164 D2588P063 Use And Care Manual

Light Bulb Replacement

REMOVE SCREW
To replace cooktop light, first
at main fuse or
disconnect power
circuit breaker panel or pull
plug.
Remove screw on right side of
light compartment cover and lower
cover until it stops.
Be sure bulbs to be replaced are
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (WB02X4253)
available from your GE supplier.
High intensity 40-watt bulbs
(40S 11 N/l ), which are available in
supermarkets and hardware stores,
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
28
Oven Light
To replace your oven light, first
disconnect power at main fuse or
circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold it
in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
your GE supplier.
Clean off the grease and dust on
hood surfaces ~) ften. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
r
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1 )
use of the grounding plug ~an
result in a risk of electric shock.
PREFERRED METHOD
Ensure proper ground
Fig. 1 exists before use
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong
wall receptacle is encountered, it
is your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord
with this appliance.