Honda CBR250R Owner's Manual page 99

10/11/05 11:28:59 32KYJE00_099
5. Check rear axle alignment by making
sure the chain adjuster index marks ( )
align with the rear edge ( ) of the
adjusting slots.
Both left and right marks should
correspond. If the axle is misaligned, turn
the left or right adjusting nut until the
marks correspond on the rear edge of the
adjusting slots and recheck chain slack.
6. Tighten the rear axle nut to the specified
torque.
Rear axle nut torque:
88 N·m (9.0 kgf·m , 65 lbf·ft)
If a torque wrench is not used for this
installation, see your dealer as soon as
possible to verify proper assembly.
7. Tighten the drive chain adjusting nuts
4 lightly, then tighten the drive chain lock
5 nuts by holding the drive chain adjusting
nuts with a spanner.
8. Recheck drive chain slack.
89