Table of Contents
Advertisement
VALVE CLEARANCE INSPECTION AND ADJUSTMENT
Adjustment steps:
Adjust the pilot air screw.
Refer to "PILOT AIR SCREW ADJUST-
MENT" section.
Turn the throttle stop screw 1 until the
specified engine idling speed.
To increase idling speed
Turn the throttle stop screw 1 in a.
To decrease idling speed
Turn the throttle stop screw 1 out b.
Inductive tachometer:
YU-08036-B/90890-03113
Engine idling speed:
1,300 ~ 1,500 r/min
VALVE CLEARANCE INSPECTION AND
ADJUSTMENT
NOTE:
The valve clearance should be adjusted
when the engine is cool to the touch.
The piston must be at Top Dead Center
(T.D.C.) on compression stroke to check or
adjust the valve clearance.
1. Remove:
Seat
Fuel tank
Refer to "SEAT, FUEL TANK AND SIDE
COVERS" section in the CHAPTER 4.
2. Remove:
Spark plug
Intake tappet cover 1
Exhaust tappet cover 2
O-ring
3. Remove:
Timing mark accessing screw 1
Crankshaft end accessing screw 2
O-ring
3 - 11
INSP
ADJ
Advertisement
Table of Contents
