Rear Brake Adjustment - Yamaha YZ250F(W) Owner's Service Manual

FRONT BRAKE PAD INSPECTION AND REPLACEMENT
È

REAR BRAKE ADJUSTMENT/

É
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
• Brake pedal height a
Out of specification → Adjust.
Brake pedal height a:
5 mm (0.20 in)
2. Adjust:
• Brake pedal height
Pedal height adjustment steps:
• Loosen the locknut 1.
• Turn the adjusting nut 2 until the pedal
height a is within specified height.
• Tighten the locknut.
WARNING
• Adjust the pedal height between the
maximum È and the minimum É as
shown. (In this adjustment, the bolt 3
end b should protrude out of the
threaded portion 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
• After the pedal height adjustment, make
sure that the rear brake does not drag.
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
• Brake pad thickness a
Out of specification → Replace as a set.
Brake pad thickness:
4.4 mm (0.17 in)
<Limit>: 1.0 mm (0.04 in)
2. Replace:
• Brake pad
Brake pad replacement steps:
• Remove the pad pin plug 1.
3 - 25
INSP
ADJ