Yamaha YZ250F(D) Owner's Service Manual page 136

Yz series
Table of Contents

Advertisement

Clean the contacting surface of left
and right crankcase before applying
the sealant.
5. Install:
• Dowel pin "1"
• O-ring "2"
• Right crankcase
To left crankcase.
• Apply the lithium soap base grease
on the O-ring.
• Fit the right crankcase onto the left
crankcase. Tap lightly on the case
with soft hammer.
• When installing the crankcase, the
connecting rod should be posi-
tioned at TDC (top dead center).
6. Tighten:
• Hose guide "1"
• Clutch cable holder "2"
• Bolt (crankcase) "3"
Bolt (crankcase):
12 Nm (1.2 m•kg, 8.7
ft•lb)
Tighten the crankcase tightening
bolts in stage, using a crisscross pat-
tern.
CRANKCASE AND CRANKSHAFT
7. Install:
• Oil delivery pipe 2 "1"
• O-ring "2"
• Bolt (oil delivery pipe 2) "3"
Bolt (oil delivery pipe 2):
10 Nm (1.0 m•kg, 7.2
ft•lb)
Apply the lithium soap base grease
on the Orings.
8. Install:
• Timing chain "1"
• Timing chain guide (intake side)
"2"
• Bolt (timing chain guide) "3"
Bolt (timing chain guide):
10 Nm (1.0 m•kg, 7.2
ft•lb)
9. Remove:
• Sealant
Forced out on the cylinder mating
surface.
10. Apply:
• Engine oil
To the crank pin, bearing and oil
delivery hole.
11. Check:
• Crankshaft and transmission op-
eration.
Unsmooth operation → Repair.
4-62

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yz250f b 2012Yz250f 20122013 yz250f2013 yz250fd

Table of Contents