Yamaha YZ250F(Y) Owner's Service Manual page 135

Table of Contents

Advertisement

2. Install:
• Brake disc "1"
• Bolt (brake disc) "2"
Bolt (brake disc):
12 Nm (1.2 m•kg, 8.7
ft•lb)
Tighten the bolts in stage, using a
crisscross pattern.
3. Install:
• Collar "1"
• Apply the lithium soap base grease
on the oil seal lip.
• Install the collars with their projec-
tions "a" facing the wheel.
4. Install:
• Wheel
Install the brake disc "1" between the
brake pads "2" correctly.
5. Install:
• Wheel axle "1"
Apply the lithium soap base grease
on the wheel axle.
FRONT WHEEL AND REAR WHEEL
6. Install:
• Nut (wheel axle) "1"
Nut (wheel axle):
105 Nm (10.5 m•kg, 75
ft•lb)
7. Tighten:
• Bolt (axle holder) "1"
Bolt (axle holder):
21 Nm (2.1 m•kg, 15
ft•lb)
Before tightening the bolt, fit the
wheel axle to the axle holder by strok-
ing the front fork several times with
the front brake applied.
INSTALLING THE REAR WHEEL
1. Install:
• Bearing (right) "1"
• Circlip "2"
• Spacer "3"
• Bearing (left) "4"
• Oil seal "5"
• Apply the lithium soap base grease
on the bearing and oil seal lip when
installing.
• Install the bearing with seal facing
outward.
• Use a socket that matches the out-
side diameter of the race of the
bearing.
• Right side of bearing shall be in-
stalled first.
• Install the oil seal with its manufac-
ture's marks or numbers facing out-
ward.
5-4
Do not strike the inner race of the
bearing. Contact should be made
only with the outer race.
2. Install:
• Brake disc "1"
• Bolt (brake disc) "2"
Bolt (brake disc):
14 Nm (1.4 m•kg, 10
ft•lb)
Tighten the bolts in stage, using a
crisscross pattern.
3. Install:
• Rear wheel sprocket "1"
• Bolt (rear wheel sprocket) "2"
• Washer (rear wheel sprocket) "3"
• Nut (rear wheel sprocket) "4"
Nut (rear wheel sprock-
et):
42 Nm (4.2 m•kg, 30
ft•lb)
Tighten the nuts in stage, using a
crisscross pattern.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2009 yz250f2009 yz250fy

Table of Contents