8 SETUP/MAINTENANCE
MPJ+ Joysticks
For this procedure, refer to FIGURE 9.
Disconnecting
1.
Pull the latch away from the joystick connector.
2.
Disconnect the joystick connector from the remaining connectors
Connecting
Ensure the gaskets are installed in the top
connector cap and between network connectors.
1.
Ensure the latch is pulled away from the network connector.
2.
Connect the network connector to the other connectors.
3.
Top and Bottom Connectors - Install connector caps onto the
network connector.
4.
Push the latch in to secure the network connectors and caps.
5.
If necessary secure excess cable using tie-wraps.
Invacare® FDX®
Top Connector
Cap
Network
Connectors
Controller
Cable
Bottom
Connector
Cap
FIGURE 9
Disconnecting/Connecting the Joysticks -
90
Latch
Gasket
Gasket
Gasket
MPJ+ Joysticks
Part No 1163181