Removing And Replacing The Cover Plate - Compaq SW TL881 DLT Mini-Lib/1 Reference Manual

Replacing
To replace the skin cover on the Base Module:
1. Slide the skin cover over the module until it touches the front panel.
2. Insert the four screws (2 each side) through the skin cover into the Base
Module. Do not tighten the screws yet.
3. Position the front edge of the skin cover so that it is flush against the
back of the front panel.
4. Tighten the four screws (2 each side) into the Base Module.

Removing and Replacing the Cover Plate

Removing
To remove the cover plate from the Base Module:
1. If the Base Module is a desktop model, remove the skin cover as
described in "Removing and Replacing the Skin Cover (Desktop Models
Only)."
2. Disconnect the power and interface cables at the rear of the module.
3. Unscrew the captive screw in the center of the cover plate (Figure D-3).
4. Slide the cover plate one-half inch toward the rear of the module.
5. Lift the cover plate off the Base Module.
Replacing
To replace the cover plate on the Base Module:
1. Place the cover plate on the Base Module so that it overhangs one-half
inch at the rear of the module (Figure D-3).
2. Slide the cover plate toward the front of the Base Module until the cover
plate touches the front panel.
3. Tighten the captive screw in the center of the cover plate.
Adding a Second Tape Driv D-5