Port Numbering; Hp 3Par Storeserv 7000 Controller Node Numbering - HP 3PAR StoreServ 7200 2-node Manual

Table 9 System Models and Number of Controller Nodes
Storage System Model
StoreServ 7000
StoreServ 10000
T400
T800
F200
F400

Port Numbering

The number of host ports each storage system model can accommodate is summarized in
(page 67).
Table 10 Storage System Models and Number of Ports
Storage System Model
StoreServ 7200
StoreServ 7400
StoreServ 7450
StoreServ 10000
T400
T800
F200
F400
NOTE:
For information about port location and numbering, see
For information about how to view the control cache DIMM and data cache DIMM
configurations for each controller node, see the HP 3PAR Command Line Interface
Administrator's Manual and HP 3PAR Management Console Online Help. For information
about memory expansion, contact your HP representative.
For a complete list of supported third-party hardware and software, go to the Single Point of
Connectivity Knowledge (SPOCK) website http://www.hp.com/storage/spock.

HP 3PAR StoreServ 7000 Controller Node Numbering

The HP 3PAR StoreServ 7000 Storage system can contain two or four controller nodes per system
configuration. Controller nodes are located in the rear of the node enclosure. The HP 3PAR StoreServ
7200 Storage system includes two nodes, which are numbered 0 and 1 from bottom to top. The
HP 3PAR StoreServ 7400 Storage system can include two nodes or four nodes. Four-node systems
are numbered from 0 to 3 from bottom to top.
Number of Controller Nodes
2 or 4
2, 4, 6, or 8
2 or 4
2, 4, 6, or 8
2
4
Number of FC Ports
0–12
0–12 (2 node); 0–24 (4 node)
4–12 (2 node); 8–24 (4 node)
0–288
0–64
0–128
0–8
0–16
Number of iSCSI Ports
0–4 (10 Gb/s)
0–8 (10 Gb/s)
0–4 (2 node); 0–8 (4 node) (10 Gb/s)
0–18
0–16
0–32
0–8 (1 Gb/s)
0–16 (1 Gb/s)
"Port Location Formats" (page
Controller Nodes
Table 10
28).
67