Introduction These are the Mellanox MLNX-OS™ Release Notes for HP 689638-B21. Supported Platforms, Firmware and Cables Supported Switch Systems Table 1 - Supported Switch Systems Part Number Description SX1018HP 34-Port 40Gb/s Ethernet Blade Switch System Supported CPU Architecture • PPC 460 CPU families Supported Firmware •...
Changes and New Features Table 2 - SX1018HP Changes and New Features Category Description Release 3.3.1000 U-Boot Updated U-Boot - memory access optimization WebUI Added VLAN configuration page to the WebUI Release 3.2.1302 SNMP Added support for SNMPv3 notifications General Bug fixes Release 3.2.0660 General...
Known Issues For any possible errata due to hardware issues, please refer to the switch support prod- uct page. The following table describes MLNX-OS™ known issues in this software release and possible workarounds. General Known Issues Table 3 - General Known Issues (Sheet 1 of 2) Index Category Description...
Table 3 - General Known Issues (Sheet 2 of 2) Index Category Description Possible Workaround Configuration Manage- After loading a new configuration file, please ment reboot the system. Otherwise, configuration might not be properly applied. Configuration Manage- The command Use the command reset fac- configuration revert fac- ment is removed.
Page 8
Index Category Description Possible Workaround The remote LACP admin-key #1 cannot be estab- Use a different admin-key lished with some third party vendors. number. Traffic running over LAG may not be evenly dis- tributed when testing small number of SMACs. A port-channel stops forwarding traffic after dis- Disable and enable the abling some Ethernet ports in the same port-chan-...
Bug Fixes The following table describes MLNX-OS™ bug fixes in this software release. Table 5 - Bug Fixes (Sheet 1 of 2) Index Category Description Ethernet Interfaces When trying to give a description to a port after it has been split, the command fails.
Page 10
Table 5 - Bug Fixes (Sheet 2 of 2) Index Category Description When splitting an Ethernet interface with an ACL rule, the interface remains bound by the ACL. MAC packets are discarded when the IPv4 ACL deny rule is defined. Logging SDKd process errors may appear during reload (shutdown phase) or switching system profile.