Ipv6 Enable - Mellanox Technologies Mellanox SX1018 Command Reference Manual

ipv6 enable

ipv6 enable
no ipv6 enable
Enables all IPv6 addressing for this interface.
The no form of the command disables all IPv6 addressing for this interface.
Syntax Description N/A
Default IPv6 addressing is disabled
Modes/Context Config Interface Management
History 3.1.0000
Role admin
Example
switch (config interface mgmt0) # ipv6 enable
switch (config interface mgmt0) # show interfaces mgmt0
Interface mgmt0 state
switch (config interface mgmt0) #
Admin up: yes
Link up: yes
IP address: 172.30.2.2
Netmask: 255.255.0.0
IPv6 enabled: yes
Autoconf enabled: no
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 1
IPv6 address: fe80::202:c9ff:fe5e:a5d8/64
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface ifindex: 2
Interface source: physical
MTU: 1500
HW address: 00:02:C9:5E:A5:D8
Comment: my-interface
RX bytes: 962067812
RX packets: 3738865
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0
TX bytes: 40658219
TX packets: 142345
TX discards: 0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0
TX queue len: 1000
Mellanox Technologies
Rev 1.6.2
37