Figure 20 Active/EFI prompt State of vPar
Getting a Console using the CLI
To access the system console of a partition using the command line, run the CO command. It can
be used either with the partition's ID or without it as shown:
co
Partition
Number
---------
1
2
2:1
Q)
Select partition number: 2:1
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
Shell>
Alternatively, you can also use the CONNECT PARTITION command to connect to a partition.
connect partition 2
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
Getting a Console using the GUI
To access the system console of a partition using the GUI, select the Remote Console tab, and then
click on the Remote Serial Console link.
Partition
Name
---------
nPar0001
nPar0002
nPar0002:vPar0001
Quit
<use <Ctrl-b> to exit.>
<use <Ctrl-b> to exit.>
Booting to UEFI and preparing for Operating System installation
55