Booting From The Cli - HP Integrity Superdome 2 16-socket Administrator's Manual

Booting from the CLI

To activate a partition from the command line, you can either use the poweron partition
{identifier} command, the bo command, or the pe command.
poweron partition 2
Poweron request sent to partition 2. Operation initiated successfully.
Please run PARSTATUS/VPARSTATUS or SHOW SYSLOG OA to determine the completion
status of the operation.
After you power on the nPartition, the partition firmware is booted and comes up to the Active/EFI
state if the nPartition is in nPars mode or to Active/RUN_VPARS state if the nPartition is in vPars
mode.
parstatus -P
[Partition]
Par State/
Num RunState
=== ======================= ======= ====== ====== ============= ===============
1 Inactive /DOWN
2 Active /RUN_VPARS
3 Active /EFI
4 Inactive /DOWN
5 Inactive /DOWN
* D-Degraded
** Actual allocated for Active and User requested for Inactive partitions
Status* # of # of
Blades IOBays SLM
OK 1 0
OK 2 2
OK 1 2
OK 0 0
OK 0 0
Booting to UEFI and preparing for Operating System installation
ILM/ Partition Name
(first 15
(GB)** characters)
0.0/0.0 nPar0001
2.0/28.0 nPar0002
2.0/28.0 hard_partition
0.0/0.0 nPar0004
0.0/0.0 nPar0005
51