•
Four small form-factor SFP GBIC GbE ports, providing a fast link to an IP network for devices
on the InfiniBand fabric
•
An RJ-45 management port.
Figure 6-6
shows the front panel of the IPR blade.
Figure 6-6 IPR Blade Front Panel
1
Figure 6-6
shows the following features of the IPR blade:
1.
The link/activity LEDs, labelled 1 – 4, one for each labelled port.
2.
Gigabit Ethernet ports, labelled Et1 – Et4.
3.
1, 2, and Sys LEDs that provide the following status:
•
Link status of the combined interfaces in the integrated management port
•
Overall system status.
4.
Management RJ-45 port, with status LEDs.
You can replace the SFP GBIC port to configure GbE interface for optional connection types,
such as MTRJ, FC, LC, or copper. A status LED is located next to each port.
IPR LEDs and provides a description of the status signalled by these LEDs
Table 6-5 IPR Blade LEDs
LED Label
Link/Activity
(1–4)
System
GbE
InfiniBand
6.6.2 Overview of the FCR (Fibre Channel Router) Blade
The FCR router blade provides four 1G/2G Fibre Channel ports for optimum InfiniBand over
FC communication.
78
Installing Field-Replaceable Units in the ISR 9XXX Chassis
2
3
4
Color and State
Description
Flashing green
Port is operational and Ethernet packets are detected.
Illuminated green
Boot sequence is completed and the system is operational.
Flashing green
Boot sequence initiated and in process.
Flashing green
Port is operational and Ethernet packets are detected.
Illuminated amber
Port is operational and a physical link exists between the port and the
InfiniBand fabric.
Illuminated green
Green Port is operational and has a logical connection to the InfiniBand
fabric.
Figure 6-7
shows the front panel of the FCR blade.
Table 6-5
lists the