Yamaha YZ450F(W) Owner's Service Manual page 316

Table of Contents

Advertisement

VALVES AND VALVE SPRINGS
5. Measure:
NOTE:
• When installing a new valve always replace
the guide.
• If the valve is removed or replaced always
replace the oil seal.
6. Eliminate:
7. Inspect:
8. Measure:
Measurement steps:
• Apply Mechanic's blueing dye (Dykem) b
• Install the valve into the cylinder head.
• Press the valve through the valve guide
• Measure the valve seat width. Where the
• If the valve seat is too wide, too narrow, or
4 - 38
• Runout (valve stem)
Out of specification → Replace.
Runout limit:
0.01 mm (0.0004 in)
• Carbon deposits
(from the valve face and valve seat)
• Valve seats
Pitting/wear → Reface the valve seat.
• Valve seat width a
Out of specification → Reface the valve
seat.
Valve seat width:
Intake:
0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in)
<Limit>: 1.6 mm (0.0630 in)
Exhaust:
0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in)
<Limit>: 1.6 mm (0.0630 in)
to the valve face.
and onto the valve seat to make a clear
pattern.
valve seat and valve face made contact,
blueing will have been removed.
the seat is not centered, the valve seat
must be refaced.
ENG

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yz450f 2007Yz450f w 2007Yz450f 2006Yz450fw 2006

Table of Contents