Yamaha YZ450F(W) Owner's Service Manual page 306

Table of Contents

Advertisement

CYLINDER HEAD
• Remove the bolts.
• Again apply the molybdenum disulfide
grease on the threads and contact sur-
faces of the bolts and on both contact sur-
faces of the plain washers.
• Retighten the bolts.
NOTE:
Tighten the bolts to the specified torque in
two or three steps in the proper tightening
sequence as shown.
1
• Put a mark on the corner 1 of the bolt
(cylinder head) and the cylinder head 2
2
as shown.
NOTE:
Tighten the bolts 90° in each of the two
steps to reach the specified angle of 180° in
the proper tightening sequence as shown.
180˚
3. Install:
4 - 33
Bolts (cylinder head):
2nd:
20 Nm (2.0 m • kg, 14 ft • lb)
Bolts (cylinder head):
Final:
Specified angle 180°
• Bolt (cylinder head) 1
10 Nm (1.0 m · kg, 7.2 ft · lb)
ENG

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yz450f 2007Yz450f w 2007Yz450f 2006Yz450fw 2006

Table of Contents