Yamaha YZ450F(W) Owner's Service Manual page 186

Table of Contents

Advertisement

VALVE CLEARANCE ADJUSTMENT
3 - 21
• Round off the last digit of the installed pad
number to the nearest increment.
Last digit of pad
number
0, 1 or 2
4, 5 or 6
8 or 9
EXAMPLE:
Installed pad number = 148
Rounded off value = 150
NOTE:
Pads can only be selected in 0.05 mm incre-
ments.
• Locate the rounded-off value and the mea-
sured valve clearance in the chart "PAD
SELECTION TABLE". The field where
these two coordinates intersect shows the
new pad number to use.
NOTE:
Use the new pad number only as a guide
when verifying the valve clearance adjust-
ment.
• Install the new pads 6 and the valve lift-
ers 7.
NOTE:
• Apply the engine oil on the valve lifters.
• Apply the molybdenum disulfide oil on the
valve stem ends.
• Valve lifter must turn smoothly when
rotated with a finger.
• Be careful to reinstall valve lifters and
pads in their original place.
• Install the camshafts (exhaust and intake),
the timing chain and the camshaft caps.
Refer to "CAMSHAFTS" section in the
CHAPTER 4.
Bolt (camshaft cap):
10 Nm (1.0 m • kg, 7.2 ft • lb)
INSP
ADJ
Rounded value
0
5
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yz450f 2007Yz450f w 2007Yz450f 2006Yz450fw 2006

Table of Contents