Editing An Port Offline Policy - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

Supporting dcfm 10.4.x
Hide thumbs Also See for Brocade BladeSystem 4/24:
Table of Contents

Advertisement

10

Editing an Port offline policy

To edit an Port offline policy, complete the following steps.
1. Select Monitor > Event Policies.
2. Select the policy you want to edit in the Policies table.
3. Click Edit.
4. Edit the trigger in the IP Address, Node WWN, and Name list.
5. Change the count value (between 2 and 999) in the Count field.
6. Change the duration value (between 1 and 999) in the Duration field.
7.
8. Select the check box in the Actions list for each action you want to occur when this policy is
9. Click OK on the Edit Event Policy dialog box.
10. Select the Active check box to activate the policy.
11. Click OK on the Event Policies dialog box.
270
The Event Policies dialog box displays.
The Edit Event Policy dialog box displays.
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
Select the duration type (Seconds or Minutes) from the Duration list.
The maximum duration is 30 minutes.
triggered.
For a list of the available actions, refer to
refer to
"Defining the broadcast message action"
action"
on page 262,
"Defining the send e-mail action"
data capture action"
on page 264.
"Policy actions"
on page 257. To define an action,
on page 261,
"Defining the launch script
on page 263, or
DCFM Professional Plus User Manual
"Configuring support
53-1001774-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcfm professional plus

Table of Contents