Moving A Logical Switch To A Different Fabric - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

21

Moving a logical switch to a different fabric

4. Click OK on the Logical Switches dialog box.
5. Select the Re-Enable ports after moving them check box.
6. (Optional) Select the Unbind Port Addresses while moving them check box.
7.
8. When the changes are complete, click Close.
Moving a logical switch to a different fabric
You can move a logical switch from one fabric to another by assigning a different fabric ID.
1. Select a switch on the Product List or Connectivity Map and select Configure > Logical
2. Right-click anywhere in the Existing Logical Switches table and select Table > Expand All.
3. Select the logical switch you want to move to another logical fabric.
4. Click Edit.
5. Change the FID in the Logical Fabric ID field.
6. Click OK on the Edit Properties dialog box.
7.
8. Select the Re-Enable ports after moving them check box.
9. (Optional) Select the Unbind Port Addresses while moving them check box.
600
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
NOTE
Ports are disabled before moving from one logical switch to another.
Click Start to send these changes to the affected chassis.
NOTE
Most changes to logical switches will disrupt data traffic in the fabric.
The status of each change is displayed in the Status column and Status area in the dialog box.
Switches.
The Logical Switches dialog box displays.
The Edit Properties dialog box displays.
The logical switch displays under the new logical fabric node in the Existing Logical Switches
table.
Click OK on the Logical Switches dialog box.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
NOTE
Ports are disabled before moving from one logical switch to another.
DCFM Enterprise User Manual
53-1001775-01