20
Adding encryption targets
Adding encryption targets
Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators
within the encryption switch.
NOTE
It is recommended that you zone the host and target together before configuring them for
encryption. If the host and target are not already zoned, you can still configure them for encryption,
but afterward you will need to zone the host and target together, and then click the Commit button
to commit the changes. If you attempt to close the Encryption Targets dialog box without committing
the changes, you are reminded of uncommitted changes in the Management application.
1. Select Configure > Encryption from the menu bar.
2. Select the encryption group, switch, or encryption engine to which you want to add the target.
3. Select Targets.
4. Click Add.
FIGURE 236
544
The Encryption Center dialog box displays.
Right-click, or select Group, Switch, or Engine from the menu bar.
The Encryption Targets dialog box displays.
The Configure Storage Encryption welcome panel displays. The welcome panel explains the
wizard's purpose, which is to configure encryption for a storage device (target).
Configure Storage Encryption welcome panel
DCFM Enterprise User Manual
53-1001775-01