19
Connecting edge fabrics to a backbone fabric
Connecting edge fabrics to a backbone fabric
The following procedure explains how to set up FC-FC routing on two edge fabrics connected
through an FC router using E_Ports and EX_Ports.
If you are connecting Fibre Channel SANs through an IP-based network, see
tunnel"
VEX_Port.
ATTENTION
Be sure that you do not physically connect a port to the remote fabric before configuring it as an
EX_Port; otherwise, the two fabrics merge and you lose the benefit of FC-FC routing.
1. Select the edge fabric you want to connect to an FC router from the Connectivity Map or
2. Right-click the edge fabric in the Connectivity Map or Product List and select Router
490
on page 391 for instructions on setting up an FCIP tunnel between a VE_Port and a
Product List.
Configuration.
The Router Configuration-Connect Edge Fabric dialog box is displayed
fabric you selected is also displayed in the title of the dialog box. Discovered extension
switches capable of FC routing are displayed in the Available Routers table.
NOTE
If the configuration includes virtual fabrics, only the base switch displays in the Available
Routers table.
FIGURE 206
Router Configuration-Connect Edge Fabric dialog box
"Configuring an FCIP
(Figure
206). The edge
DCFM Enterprise User Manual
53-1001775-01