Activating A Pdcm Configuration - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

18

Activating a PDCM configuration

Activating a PDCM configuration
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
You must have an active zone configuration before you can activate a PDCM configuration.
1. Select Configure > Allow/Prohibit Matrix.
2. Select the PDCM configuration you want to activate. You can do this by expanding the view for
3. Click Activate.
4. Select the Active=Saved check box to save the active configuration as the startup
5. Click OK to confirm.
474
The Configure Allow/Prohibit Matrix dialog box displays.
the switch under Available Switches and selecting a configuration, or you may select the matrix
under PDCM Matrix.
A confirmation message displays.
FIGURE 202
Activate Matrix Confirmation message
configuration (IPL).
If you select the Active=Saved check box, the text [=Active] is appended to the IPL file in the
Configure Allow/Prohibit Matrix dialog box.
The Active=Saved check box and IPL filename represent the current state of the Active=Saved
Mode (ASM) bit on the switch. However, this is limited to changes done to the ASM
configuration through the Management application. If changes occur through external means
(such as, Webtools/CLI) the changes are not reflected in the Management application until the
PDCM dialog box is re-launched.
DCFM Enterprise User Manual
53-1001775-01