Editing The Hp Lan Call Home Center - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

4

Editing the HP LAN call home center

7.
8. Enter the identification number of the local server in the Local Server - Cabinet Serial # field.
9. Enter the site name for the local server in the Local Server - Site Name field.
10. Click Send Test to test the Connect EMC application.
11. Click OK.
12. Click OK to close the Call Home dialog box.
Editing the HP LAN call home center
To edit an HP LAN call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
2. Select the HP LAN call home center you want to edit in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
FIGURE 53
4. Make sure the HP LAN call home center type displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Enter the IP address of the call home center in the Service Gateway field.
7.
114
Enter the phone number or extension of the local server in the Local Server - Modem # field.
The selected call home center must be enabled to test the Connect EMC application.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
The Call Home dialog box displays.
The Configure Call Home Center dialog box displays
Configure Call Home Center dialog box (HP LAN option)
Enter the port number (default is 2069) of the call home center in the Port field
(Figure 53).
DCFM Enterprise User Manual
53-1001775-01