Reverting To A Default Snmp Community String; Removing A Fabric From Active Discovery - Brocade Communications Systems Brocade 8/12c User Manual

19. Click OK on the Add Fabric Discovery dialog box.
20. Click Close on the Discover Fabrics dialog box.

Reverting to a default SNMP community string

To revert to the default SNMP parameters, complete the following steps.
1. Select Discover > Fabrics.
2. Select an IP address from the Discovered Fabrics table.
3. Click Edit.
4. Select the Automatic option.
5. Click OK on the Add Fabric Discovery dialog box.
6. Click Close on the Discover Fabrics dialog box.

Removing a fabric from active discovery

If you decide you no longer want the Management application to discover and monitor a specific
fabric, you can delete it from active discovery. Deleting a fabric also deletes the fabric data on the
server (both system collected and user-defined data) except for user-assigned names for the device
port, device node, and device enclosure information.
To delete a fabric from active discovery, complete the following steps.
1. Select Discover > Fabrics.
2. Select the fabric you want to delete from active discovery in the Discovered Fabrics table.
3. Click Delete.
4. Click OK on the confirmation message.
5. Click Close on the Discover Fabrics dialog box.
Brocade Network Advisor SAN User Manual
53-1002167-01
If the seed switch is not partitioned, continue with
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
The Discover Fabrics dialog box displays.
The Add Fabric Discovery dialog box displays.
The Discover Fabrics dialog box displays.
The deleted fabric displays in the Previously Discovered Addresses table.
SAN discovery overview
step 20.
3
55