18
Adding target disk LUNs for encryption
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard. To launch the wizard, complete the following steps:
Before You Begin
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays.
For more information, see
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
FIGURE 233
3. Click Add.
FIGURE 234
522
"Configuring Storage Arrays"
The Encryption Center dialog box displays
Group/Switch/Engine > Disk LUNs from the menu task bar, or right-click a group, switch, or
engine and select Disk LUNs.
The Encryption Disk LUN View dialog box displays
Encryption Disk LUN View dialog box
The Select Target Port dialog box displays
Select Target Port dialog box
on page 525.
(Figure
153).
(Figure
233).
(Figure
234).
Brocade Network Advisor SAN User Manual
53-1002167-01