Brocade Communications Systems Brocade 8/12c User Manual page 435

7.
8. Click OK on the Device_Name - L2 ACL Configuration dialog box.
Creating an extended L2 ACL configuration
To create an extended L2 ACL configuration on a Fabric OS device, complete the following steps.
1. Select the device and select Configure > Security > L2 ACL > Product.
2. Select New from the Add list.
3. Select Extended from the Type list.
Brocade Network Advisor SAN User Manual
53-1002167-01
a. Enter the sequence number for the ACL in the Sequence field.
b. Select Permit or Deny from the Action list.
c. In the Source list, select one of the following options:
•
Any
•
MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
d. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
e. Click the right arrow button.
The new ACL entry displays in the ACL Entries table. To add additional ACL entries, repeat
step 6.
Click OK on the Duplicate - L2 ACL Configuration dialog box.
The new ACL configuration displays in the ACLs table. To copy additional ACLs, repeat
through step 10.
The Deploy to Products - L2 ACL dialog box displays. To save the configuration, refer to
a security configuration deployment"
The Device_Name - L2 ACL Configuration dialog box displays.
The Device_Name - L2 ACL Configuration dialog box displays.
FIGURE 144 Device_Name
Layer 2 access control list management
on page 402
- L2 ACL Configuration (Extended) dialog box
15
step 2
"Saving
391