Fcoe Provisioning - Brocade Communications Systems Brocade 8/12c User Manual

Brocade network advisor san user manual v11.1x (53-1002167-01, may 2011)
Hide thumbs Also See for Brocade 8/12c:
Table of Contents

Advertisement

4. Click the Assign a map check box.
5. Select Traffic Class in the Map Type list.
6. Select a Traffic Class Map in the Traffic Class Map list.
7.

FCoE provisioning

The Management application supports FCoE provisioning only on Fabric OS (FOS) version
6.3.1_dcb. However, the Brocade command line interface supports FCoE provisioning for the
following versions of FOS: FOS 6.3.1_cee, FOS 6.4.1_fcoe, and FOS 7.0.0. Refer to the Fabric OS
Command Reference Manual for CLI procedures.
FCoE provisioning simplifies the number of steps required to configure a DCB port to carry the FCoE
traffic. The FCoE map contains the default DCB Map and the VLAN ID. You can change the default
VLAN ID using the FCoE tab of the Edit Switch dialog box, shown in
NOTE
The default DCB map associated with the default FCoE map can be edited on the switch from the
QoS tab.
Brocade Network Advisor SAN User Manual
53-1002167-01
FIGURE 126
QoS, assign a traffic class map to a port dialog box
When you have finished the configuration, click OK to launch the Deploy to Ports/LAGs dialog
box. Refer to
"Product, Port, and LAG Deployment"

FCoE provisioning

on page 373 for more information.
Figure
127.
14
359

Advertisement

Table of Contents
loading

This manual is also suitable for:

Network advisor 11.1.xBrocade bladesystem 4/24

Table of Contents