Brocade Communications Systems Brocade 8/12c Command Reference Manual page 959

--set
--default
--enable
--disable
Fabric OS Command Reference
53-1001764-01
Sets the SNMP agent configuration data of the specified category. This operand
displays the current settings and then prompts you to change the values for each
parameter.
Sets the SNMP agent configuration data for a specified item to the default values.
Generally, these default values may be available in the configuration database.
The command sets to factory defaults if the SNMP agent configuration
parameters are not available in the configuration database.
Enables the SNMP agent configuration for the specified category. This operand is
valid only with mibCapability and snmpv1. When used with the snmpv1
operand, this command restores access to SNMPv1/v2c.
Disables the SNMP agent configuration for the specified category. This operand is
valid only with mibCapability and snmpv1. When used with the snmpv1
operand, this command blocks access to SNMPv1/v2c. All requests for v1/v2c
version will be dropped by the switch, and SNMPv1 traps will be blocked from
being sent, even if trap destinations are present.
snmpv1
Selects SNMPv1-related configuration parameters. These parameters include the
community string, trap recipient IP address, and trap severity level associated with
each trap recipient IP address. When "0" is configured as a trap port, traps can be
received at the default port 162.
snmpv3
Selects SNMPv3-related configuration parameters. These parameters include the
user name, authentication protocol and password, the privacy protocol and
password, the SNMPv3 trap recipient's IP address, its associated user index and
trap severity level. When "0" is configured as a trap port, traps can be received at
the default port 162.
The --set snmpv3 command supports an interactive option to enable or disable
informs by setting the parameter "SNMP Informs Enabled" to true or false. If
informs are enabled, all trap destinations receive inform requests. If informs are
disabled, all trap destinations receive trap requests. When informs are enabled,
the engine ID must be set to correspond to the management engine IP address
(see example). Informs are by default disabled. IPv6 Informs are currently not
supported.
accessControl
Selects access-control-related parameters. These parameters include the access
host subnet area and access permission (read-write).
mibCapability
Selects configuration parameters related to the SNMP agent's MIBs and trap
capability parameters. These parameters include MIBs and traps supported by the
SNMP agent.
systemGroup
Selects configuration parameters related to the system group. These parameters
include sysDescr, sysLocation, sysContact, and authentication failure trap.
secLevel
Sets the SNMP security level.
22
snmpConfig
925