Portcfgcompress - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

portCfgCompress

portCfgCompress
Configures a port for compression.
SYNOPSIS
portcfgcompress --enable [slot]/port
portcfgcompress --disable [slot]/port
portcfgcompress --help
DESCRIPTION
Use this command to configure a port for compression. This command enables or disables the
compression configuration on the specified port, and saves the configuration persistently.
Configuring a port for compression is disruptive. You must disable the port before you can enable
compression on the port. This command fails on an enabled port.
The number of configurable ports is limited per ASIC. Use the portEncCompShow for a listing of
configurable ports per ASIC.
NOTES
This command is supported only on E_Ports. An E_Port can be enabled for compression and for
encryption at the same time.
When you move a configured port to another logical switch, you are informed that the operation requires
the port configuration to be disabled. You are given the choice to cancel the move or to continue. If you
want to go ahead with the move and the port is configured for encryption or compression, you must
disable the configuration prior to moving the port. You must reconfigure the port on the target switch if
you want to use compression or encryption on that port.
This command is supported only on Condor 3-based platforms running Fabric OS v7.0.0 or later.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
slot
port
--enable
--disable
--help
EXAMPLES
To enable the compression configuration:
632
On bladed systems only, specifies the slot number of the ports to be configured,
followed by a slash (/).
Specifies the port to be configured.
Enables the compression configuration on the specified port.
Disables the compression configuration on the specified port.
Displays the command usage.
switch:admin> portcfgcompress --enable 2
switch:admin> lscfg --config 15 -port 2
This operation requires that the affected ports be disabled.
Would you like to continue [y/n]?: y
Checking for cap port 2
After Checking for cap port 2
Fabric OS Command Reference
53-1001764-01