Frureplace - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

fruReplace

fruReplace
Provides an interactive interface to help replace a field replaceable unit (FRU).
SYNOPSIS
frureplace fru
DESCRIPTION
Use this command to replace a FRU. The command automatically performs the necessary backup and
restore operations to accommodate the replacement.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
The following operand is required:
fru
EXAMPLES
To replace the world wide name card:
SEE ALSO
None
384
Specify the type of hardware component being replaced. WWN is the only
supported value, specifying the replacement of the WWN card.
switch:admin> frureplace wwn
This is the WWN card hot swap interface.
Continuing from this point will require
the whole process to be completed.
If this process is not complete due to a
power cycle, or CP failover, please follow
the recovery procedure in
Core Switch WWN Card
Replacement Procedure (for appropriate chassis).
Do you wish to continue [y/n]? y
Backing up WWN card data, please
wait about 25 seconds for further
instruction.
Please install the new FRU now.
If this session lost for any reason,
please re-enter the frureplace command and
follow the instructions to complete the
operation.
Please enter the word `continue' after the
new WWN card has been installed: continue
Restoring the information to the
replacement FRU now, please wait about
20 seconds to complete
Verifying the replacement FRU now...
WWN card hot swap is now complete.
FRU replacement completed successfully!
Fabric OS Command Reference
53-1001764-01