Fcrchiptest - Brocade Communications Systems Brocade 8/12c Command Reference Manual

Brocade fabric os command reference manual supporting fabric os v7.0.0 (april 2011)
Hide thumbs Also See for Brocade 8/12c:
Table of Contents

Advertisement

fcrChipTest

Tests the functionality of FC Router FPGA.
SYNOPSIS
fcrchiptest
[--slot slot]
[-unit number]
[-testtype type]
DESCRIPTION
Use this command to test the FC Router Field-programmable gate array (FPGA). This test verifies that
all SRAM and register data bits in each ASIC can be independently written and read successfully.
The method used is to write a walking 1 pattern to each location. This is accomplished by writing a
pattern of 0x00000001 to register N, performing a direct memory access (DMA) read, and ensuring that
the same pattern previously written is read back. Shift the pattern to the left by 1 bit (to 0x00000002),
repeat the write, read, and compare the cycle. Shift again and repeat until the last writable bit in register
N is reached (0x80000000 for a 32-bit register).
For example, a 6-bit register is effectively tested with the following patterns:
Repeat the steps until all FPGA registers are tested.
The built-in self test (BIST) runs to verify the static random access memory (SRAM) of the FPGAs.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This command is supported only on the Brocade FR4-18i.
OPERANDS
This command has the following operands:
--slot slot
-testtype type
-unit number
Fabric OS Command Reference
53-1001764-01
0x0001 0x0002 0x0004 0x0008
0x0010 0x0020 0x0040 0x0080
0x0100 0x0200 0x0400 0x0800
0x1000 0x2000 0x4000 0x8000
Specifies the slot number on which the diagnostic operates. The default is 0.
Specifies the test type to run. By default, the command runs all tests. Valid tests
include the following:
0
All tests
1
DMA test
2
SRAM BIST test
Specifies the FC Router FPGA to test. By default, all FC Router FPGA in the
specified slot are used. Valid number values include the following:
0
FC Router FPGA 0
1
FC Router FPGA 1
22
fcrChipTest
299

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.0.0

Table of Contents