Brocade Communications Systems Brocade 8/12c Command Reference Manual page 307

-path mode
-nframes count
-length data_length
-compress mode
DIAGNOSTICS
When it detects failures, the test may report one or more of the following error messages:
PATH_TEST_ERR
PATH_TEST_CHIP_INIT_ERR
PATH_TEST_IMAGE_ERR
PATH_TEST_TIMEOUT_ERR
PATH_TEST_HEARTBEAT_ERR
PATH_TEST_INVALID_RESULT
PATH_TEST_GE_PORT_ENABLE_ERR
PATH_TEST_GE_PORT_DISABLE_ERR
Fabric OS Command Reference
53-1001764-01
2
External (SERDES) loopback
7
Backend bypass and port loopback
Specifies the loopback mode for the test on the Brocade FR4-18i only. By default,
fcipPathTest uses the PHY and central ASIC loopback modes. You can specify
one of the following alternate loopback modes:
1
SFP loopback
2
PHY loopback
3
FCIP FPGA GMAC loopback
4
FCIP FPGA FC loopback
5
Central ASIC FC loopback
7
SFP and central ASIC FC loopback
8
PHY and central ASIC FC loopback
9
FCIP FPGA GMAC and central ASIC FC loopback
Specifies the number of frames to send. The test progresses until the specified
number of frames is transmitted on each port. The default value is 100 (Brocade
FR4-18i and Brocade 7800/FX8-24).
Specifies the data length of the frames used in the test (Brocade FR4-18i only).
The default is 1,024; the maximum is 2,112 FC frames and 8,196 data packets.
Specifies the compression device for which to select or to bypass data
compression for the test (Brocade FR4-18i only). By default, data compression is
used. This setting is applicable only to path mode 1 and 2.
22
fcipPathTest
273