New_Node_Wwn [New_Slot] - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22
cryptoCfg
--delete -container
--failback -EE
--move -container
190
This operand is optional. You may add initiators at the time when the CTC is
created or any time thereafter with the --add -initiator command. The following
operands are required when specifying an initiator:
initiator_PWWN
Specifies the initiator port WWN.
initiator_NWWN
Specifies the initiator node WWN.
Deletes a specified CTC. This command removes the virtual target and
associated LUNs from the fabric. Before issuing this command, you must stop all
traffic to the target port for which the CTC is being deleted. Failure to do so results
in I/O failure between the initiators and that target Port.
This command is valid only on the group leader. The following operand is required
when deleting a CTC:
crypto_target_container_name
Specifies the name of the CTC to be deleted. Use the cryptocfg --show
-container command for a listing of valid CTC names.
Performs a manual failback of all CTCs that were failed over earlier to another
encryption engine within an HA cluster to a "new" specified encryption engine.
This command generates an error if the specified current encryption engine and
new encryption engine are not members of the same HA cluster or if the current
encryption engine or the new encryption engine are offline.
This command is valid only on the group leader. The following operands are
required:
current_node_WWN [current_slot]
Specifies the node WWN of the current encryption engine to which failover
occurred earlier, and which is now performing all encryption tasks. On bladed
systems, specify the slot number of the current encryption engine.

new_node_WWN [new_slot]

Specifies the node WWN of the encryption engine to which failback of all CTCs
should occur. On bladed systems, specify the slot number of the new encryption
engine.
Moves the specified CTC from its currently configured encryption engine to
another encryption engine. This command is valid only on the group leader. The
EEs must be part of the same encryption group for this operation to succeed, but
they do not need to be part of the same HA cluster. This operation permanently
changes the encryption engine association of a single CTC from an existing
encryption engine to another encryption engine. To move all CTCs hosted on an
encryption engine permanently to another encryption engine, use the cryptocfg
--replace command.
This command is valid only on the group leader. The following operands are
required when moving a CTC:
crypto_target_container_name
Specifies the name of the CTC to be moved.
new_node_WWN [new_slot]
Specifies the encryption engine to which the CTC should be moved. On bladed
systems, specify the encryption engine's slot number.
Fabric OS Command Reference
53-1001764-01