Brocade Communications Systems Brocade 8/12c Command Reference Manual page 185

System attributes
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
None
EXAMPLES
To enable signature validation for downloading firmware:
To add a suffix to the uploaded file name:
To upload and list the configuration file locally:
Fabric OS Command Reference
53-1001764-01
The following system-related parameters are configurable on a Virtual
Fabric-aware switch.
system.blade.bladeFaultOnHwErrMsk
If this field is set to a value other than 0, then any nonfatal HW ASIC data parity
error causes the problem blade to be powered off. The valid range is 0x0 to 0xffff.
The default value is 0x0.
system.cpuLoad
Sets a threshold to define internally when the CPU is busy. The default threshold
is 121, which represents a CPU instantaneous load average of 1.21 in the or top
command. The range is 10 to 121 (representing CPU load thresholds of .10 to
1.21).
system.i2cTurboCnfg
For internal use only.
switch:admin> configurechassis
Configure...
cfgload attributes (yes, y, no, n): [no] y
Enforce secure config Upload/Download (yes, y, no, n): [no]
Enforce signature validation for firmware (yes, y, no, n): [no]y
Add Suffix to the uploaded file name (yes, y, no, n): [no]
Custom attributes (yes, y, no, n): [no]
system attributes (yes, y, no, n): [no]
switch:admin> configurechassis
Configure...
cfgload attributes (yes, y, no, n): [no] y
Enforce secure config Upload/Download (yes, y, no, n): [no]
Enforce signature validation for firmware (yes, y, no, n): [no]
Add Suffix to the uploaded file name (yes, y, no, n): [no] y
Custom attributes (yes, y, no, n): [no]
system attributes (yes, y, no, n): [no]
switch:admin> configupload
configupload
Protocol (scp, sftp, local) [scp]:
Server Name or IP Address [host]: 10.70.212.152
User Name [user]: admin
22
configureChassis
151