Cfgclear - Brocade Communications Systems Brocade 8/12c Command Reference Manual

cfgClear

Clears all zone configurations.
SYNOPSIS
cfgclear
DESCRIPTION
Use this command to clear all zone information in the transaction buffer. All defined zone objects in the
transaction buffer are deleted. If an attempt is made to commit the empty transaction buffer while a zone
configuration is enabled, you are warned to first disable the enabled zone configuration or to provide a
valid configuration with the same name.
After clearing the transaction buffer with the cfgClear command, use the cfgDisable command to clear
the entire zoning configuration (both the transaction buffer and the active configuration). If there is no
current active zoning configuration, or you just want to clear the transaction buffer, use the cfgSave
command to commit the transaction.
If the default zone access mode is "No Access", this command recreates the default zoning objects.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
OPERANDS
None
EXAMPLES
To clear all zones and then clear nonvolatile memory:
SEE ALSO
cfgDisable, cfgEnable,
Fabric OS Command Reference
53-1001764-01
switch:admin> cfgclear
The Clear All action will clear all Aliases, Zones, FA Zones
and configurations in the Defined configuration.
Run cfgSave to commit the transaction or cfgTransAbort to
cancel the transaction.
Do you really want to clear all configurations? \
(yes, y, no, n): [no] n
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled. Until the Effective
configuration is re-enabled, merging new switches into the
fabric is not recommended and may cause unpredictable
results with the potential of mismatched Effective Zoning
configurations.
Do you want to save Defined zoning configuration only? \
(yes, y, no, n): [no]n
cfgSave
22
cfgClear
95