Fibre Channel Port Group - Brocade Communications Systems Brocade 8/12c Reference

Object and OID
swAgtTrapRcp
1.3.6.1.4.1.1588.2.1.1.1
.4.11.1.3
swAgtTrapSeverityLevel
1.3.6.1.4.1.1588.2.1.1.1
.4.11.1.4

Fibre Channel port group

This group contains information about the physical state, operational status, performance, and
error statistics of each Fibre Channel port on the switch. A Fibre Channel port is one which
supports the Fibre Channel protocol, such as F_Port, E_Port, U_Port, or FL_Port.
Fabric OS MIB Reference
53-1002151-01
Access Description
Read-write This is the trap recipient associated with the community. If a new value
is set successfully, it takes effect immediately.
If not otherwise set, the default IP address for this trap recipient is
0.0.0.0 and the SNMP trap is not sent for the associated community
string.
With a setting of non-0.0.0.0 IP address, SNMP traps are sent to the
host with the associated community string.
Any or all of the trap recipients can be configured to send a trap for the
associated community string. The maximum number of trap recipients
that can be configured is six. If no trap recipient is configured, no traps
are sent.
The trap recipient IP address should be part of the Access Control List
for Fabric OS v2.6.1, v3.1, and v4.x (refer to the Fabric OS Command
Reference and the snmpConfig command for more information).
Read-write This is the trap severity level associated with "swAgtTrapRcp".
The trap severity level, is in conjunction with the event's severity level.
When an event occurs, and if its severity level is at or below the set
value, the SNMP trap is sent to configure trap recipients. The severity
level is limited to particular events. If a new value is set successfully, it
takes effect immediately.
This object obsoletes "swEventTrapLevel".

Fibre Channel port group

6
149