Table of Contents
Advertisement
Select speaker output
If the connected device is HDMI-CEC
compliant, you can output TV audio through
an HDMI cable. Make sure that you connect
the device to the HDMI connector on the
TV. See Connect your TV > About cables
> HDMI (Page 37).
Configure TV speakers
1. Press
.
2. Select [Setup] > [TV settings] >
[EasyLink] > [TV speakers].
3. Select an option, then press OK:
[Off]: Switch off TV speakers.
[On]: Switch on TV speakers.
[EasyLink]: Stream TV audio through
the HDMI-CEC device. Switch the TV
audio to the connected HDMI-CEC
audio device through the Adjust menu.
[EasyLink autostart]: Switch off TV
speakers automatically and stream TV
audio to the connected HDMI-CEC
audio device.
Select speaker output with the adjust menu
If [EasyLink] or [EasyLink autostart] is
selected, you can change how the TV audio
is streamed to the connected HDMI-CEC
device.
1. While you watch TV, press
2. Select [Speakers], then press OK.
3. Select one of the following, then press
OK:
[TV]: On by default.
Stream TV audio through TV and the
connected HDMI-CEC audio device
until the connected device switches to
system audio control. TV audio is then
streamed through the connected
device.
[Amplifier]: Stream audio through the
connected HDMI-CEC device. If system
audio mode is not enabled on the
device, audio continues to stream from
the TV speakers. If [EasyLink autostart]
was selected, the TV prompts the
connected device to switch to system
audio mode.
With HDMI ARC compliant device
If an HDMI-ARC compliant device is
connected through an HDMI ARC
connector to the TV, you can output TV
audio through the HDMI cable. You will not
need an additional audio cable.
1. Press
2. Select [Setup] > [TV settings] >
[EasyLink].
3. Select [HDMI1 - audio out] > [On].
4. Select one of the following, then press
OK.
5. Control playback with the TV remote
control play buttons.
Listen to another device when TV is in
standby
If available, you can press
receive audio from a connected Philips
EasyLink device while the TV is in standby
mode.
Synchronise audio
ADJUST.
If your TV is connected to a home theatre
and there is a lag between the picture and
the sound, you can synchronise them.
Switch on Audio Out Delay
1. Press
2. Select [Setup] > [TV settings] > [Sound].
3. Select [Audio out delay] > [On], then
press OK.
.
[On]: Hear the TV audio through the
connected ARC compliant device.
[Off]: Hear the TV audio through the
TV speakers, or through a device
connected through the digital audio out
connector.
If you are using a Philips home theatre,
the audio and video are automatically
synchronised.
For other home theatre brands, you
need to switch on the audio sync delay
on the TV to synchronise the audio and
video.
.
ADJUST to
EN
27
Advertisement
Table of Contents
