Display Switchover State - HP 6125G Command Reference Manual

Field
MAD ARP enabled interface:
Vlan-interface2
MAD enabled aggregation port:
Bridge-Aggregation1
MAD BFD enabled interface
Vlan-interface3
mad ip address 3.3.3.1
255.255.255.0 member 1
mad ip address 3.3.3.2
255.255.255.0 member 2

display switchover state

Syntax
display switchover state [ slot member-id ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
slot member-id: Specifies an IRF member by its member ID. If no IRF member is specified, this command
displays the master/subordinate switchover states of the master.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display switchover state to display the master/subordinate switchover states of IRF member switches.
Examples
# Display the master/subordinate switchover states of the master.
<Sysname> display switchover state
Master HA State to slot 2: Slave is absent.
Master HA State to slot 3: Realtime backup to slave.
Master HA State to slot 4: Waiting batch backup request from slave.
Description
Interface where ARP MAD is enabled.
Aggregate interface where LACP MAD is enabled.
Interface where BFD MAD is enabled.
VLAN interface used for BFD MAD, and the MAD IP address configured
for each member on this interface.
6