Irf-Port; Irf-Port-Configuration Active - HP 6125G Command Reference Manual

Examples
# Log in to the CLI of IRF member switch 2.
<Sysname> system-view
[Sysname] irf switch-to 2
<Sysname-Slave#2>

irf-port

Syntax
irf-port member-id/port-number
undo irf-port member-id/port-number
View
System view
Default level
3: Manage level
Parameters
member-id/port-number: Specifies an IRF port number. The member-id argument represents the IRF
member ID. The port-number argument represents the index of the port on the member switch, and must
be 1 or 2.
Description
Use irf-port to enter IRF port view.
Use undo irf-port to remove all port bindings on an IRF port.
To set up an IRF link between two switches, you must enter IRF port view to bind physical ports to the IRF
port used by each switch for IRF connection.
Before removing all port bindings on an IRF port, shut down all its physical ports.
Related commands: port group interface.
Examples
# Bind Ten-GigabitEthernet 3/1/1 to IRF-port 1 on member device 3.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 3/1/1
[Sysname-Ten-GigabitEthernet3/1/1] shutdown
[Sysname-Ten-GigabitEthernet3/1/1] quit
[Sysname] irf-port 3/1
[Sysname-irf-port3/1] port group interface ten-gigabitethernet 3/1/1
[Sysname-irf-port3/1] quit
[Sysname] interface ten-gigabitethernet 3/1/1
[Sysname-Ten-GigabitEthernet3/1/1] undo shutdown

irf-port-configuration active

Syntax
irf-port-configuration active
14