Configuring The Userloginwithoui Mode - HP 6125G Configuration Manual

IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-cb00-5558
Description: GigabitEthernet1/0/1 Interface
......
The port should be re-enabled 30 seconds later.
[Device-GigabitEthernet1/0/1] display interface gigabitethernet 1/0/1
GigabitEthernet1/0/1 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-cb00-5558
Description: GigabitEthernet1/0/1 Interface
......
Delete several secure MAC addresses, and you can see that the port security mode of the
port changes to autoLearn, and the port can learn MAC addresses again.

Configuring the userLoginWithOUI mode

Network requirements
As shown in
Device authenticates the client with a RADIUS server. If the authentication succeeds, the client is
authorized to access the Internet.
• The RADIUS server at 192.168.1.2 functions as the primary authentication server and the secondary
accounting server, and the RADIUS server at 192.168.1.3 functions as the secondary authentication
server and the primary accounting server. The shared key for authentication is name, and that for
accounting is money.
All users use the default authentication, authorization, and accounting methods of ISP domain sun,
•
which can accommodate up to 30 users.
The RADIUS server response timeout time is five seconds and the maximum number of RADIUS
•
packet retransmission attempts is five. The Device sends real-time accounting packets to the RADIUS
server at an interval of 15 minutes, and sends usernames without domain names to the RADIUS
server.
Configure port GigabitEthernet 1/0/1 of the Device to:
Allow only one 802.1X user to be authenticated.
•
• Allow up to 16 OUI values to be configured and allow one terminal that uses any of the OUI values
to access the port in addition to an 802.1X user.
Figure 41 Network diagram
Figure 41, a client is connected to the Device through port GigabitEthernet 1/0/1. The
125